digital CONTROL UNIT, "m.unit basic", MOTOGADGET
Informationen zu möglichen Raten
Please note that this article must be ordered for you.
This results in an additional shipping time,
which you can see in the field at the top right (below the price).
This information is subject to change, as it is based on our experience.
or based on the information provided by the supplier or the manufacturer.
We ask for your understanding!
The new m.unit basic without Bluetooth® LE has been compared to the proven
m.unit v.2 further developed and significantly improved.
It now has 12 inputs, 10 outputs and exchangeable quality cable clamps.
Thus it offers the same advantages as the m.unit blue,
but without Bluetooth® LE and connection to the m.ride app.
The m.unit basic is the digital control unit for a motorcycle,
the heart of all vehicle electrics. It can be equipped with push button fittings or with conventional,
handlebar valves can be operated. It switches all necessary components
on the vehicle and at the same time it takes over the tasks of the electrical fuses.
Relays and individual components in the wiring harness are greatly reduced and it is possible to quickly
a new, minimized wiring of the vehicle takes place.
Complete digital push-button control, 4-button or 5-button operation possible. Operation with switch also possible.
Complete replacement for the fuse box. 10 independent circuits are digitally monitored and switched off in the event of faults. After the fault has been eliminated, the fuse function is automatically reset.
Integrated alarm system with position-independent gravitational sensor
Integrated, digital, load-independent flasher relay, automatic switch-off optional and adjustable, m.wave mode selectable
Integrated hazard warning lights - also works when the ignition is switched off
Indicator optional as position light. Lecht intensity adjustable
Integrated parking light and headlamp flasher
Control of dipped beam and main beam (up to 200 W switching capacity) with just one push-button
Integrated digital brake light modulator, programmable flashing mode
Acceleration-controlled hazard brake light (automatic warning signal)
Integrated starter relay for starters with magnetic switch (up to 30 A switching capacity)
Intelligent and configurable control/switch-off of the consumers in order to be able to use the maximum starting energy of the battery during the starting process
Integrated digital horn relay
Two configurable auxiliary outputs AUX1 and AUX2
Diagnostic function for assignment of input, output, switching status of the circuit, short-circuit diagnosis etc. via 22 LEDs
Calibration and current measurement enables defect detection of all light sources
Operation of a tail light-stop light combination with only one supply line possible
the m.unit basic enables a minimal wiring harness and simple cabling - especially with m.button
absolutely waterproof and vibration-proof
scope of supply
approx. 50 cm connection cable for positive battery terminal with 10 mm² cross-section
2 cable eyes
1 x M5 stainless steel screw
2 x M5 stainless steel screw with nut
1 x speedometer sensor with 2 magnets
Detailed installation and operating instructions
|L/W/H||90 x 53 x 30 mm, hole spacing 74 mm|
|Weight||ca. 180 g|
|Fastening||2 x M5 stainless steel screws (mounting and ground connection), 1 x M5 screw contact for battery plus|
|Operating voltage||6 V - 20 V|
|Operating temperature||-20°... 80°C|
|input||1 x input (+12V switched) for lock or m.lock
11 x Control input (negative/ground switched) for:
high beam/high beam
|outputs||10 x Output (+12V) for:
Free delivery within Germany
Translated from German by DeepL
Customers also purchased
8,24 EUR RRP 14,12 EUR you save 41.7% (5,88 EUR)
67,06 EUR RRP 70,59 EUR you save 5% (3,53 EUR)