product description
Complete rear frame for the BMW R series, mono suspension strut models (1 suspension strut).
This rear frame can be exchanged for the original in no time at all without flexing or welding.
The original shock absorbers can also be used one to one.
So the look of the BMW can be changed significantly in a short time.
Dimensions:
- Length: approx. 530mm
- Width (measured outside): approx. 240mm
- Width inside the front mount: 214mm
- Ø tubes: 25mm
- Rear angle: approx. 25 ° degrees
An expert opinion is not available, but the registration is, after consultation with a motorcycle rider, expert
Experience has shown that TÜV inspectors are not a problem . If so: please ask another examiner.
The frame is powder coated in black silk matt.
Suitable for the following BMW R models with monoshock *:
- R65
- R80
- R100
- also suitable for other BMW R models with monoshock * (Please compare the dimensions before buying)
* Monoshock = Monolever = 1 shock absorber = 1-arm swingarm
Not suitable for Paralever models, see photo.
You will find a splash guard suitable for this rear frame under item number HR-ADM .
Suitable accessories to provide the base plate with a bench can be found under the following article numbers:
foam | |
20 mm | SB-S2 |
30 mm | SB-S3 |
50 mm | SB-S5 |
80 mm | SB-S8 |
Bench base plate | |
610 x 330 x 10 mm | SB-RET |
450 x 250 x 8 mm | SB-UPB |
leatherette | |
red | KL-RT |
earth brown | KL-TER |
brown | KL-BR |
vintage brown | KL-VI |
vintage beige | KL-pa |
White | KL-WS |
silver / gray | KL-SI |
black, slightly grained (large) | KL-1S |
black, grained | KL-BB |
black, grained (large) | KL-B1S |
foam rubber | |
520 x 250 x 15 mm | MOSS |
Tips for installing a sporty seat bench see tips in the Kickstartershop .
Under the article number "KA-BAU" you will find a suitable wiring harness for the rear electrical system (for rear lights & indicators).
This saves having to remove the original wiring harness when customizing the motorcycle. The original cable harness can
thus remain in the original rear frame. If a trip is due, the original frame can be done again in a few simple steps
be used. This means, for example, that the advantages of the suitcase set and the large 2-man bench for touring can be extended
be used.
Under the article number "KF-HL" you will find an aluminum fender that is the unsightly original plastic fender of all
BMW-R models replaced.
Rear frames for the other BMW models can also be found in the Kickstartershop .
Free shipping within Germany!
GB: SUBFRAME for BMW R-model, Monoshock