2 FRAME LOOP WELDING SHIMS / Sleeves for our 22mm tubes and loops
If you can't put this article into the shopping cart, we will inform you when the article is available again.
Please enter your e-mail address and confirm the incoming mail. Thanks.
Two inner sleeves for welding.
Fits into our construction tubes SR-221 and rear bar with Ø 22mm, article numbers: HR-XS4,
BU-STG, HR-V22, BU-TRP, BU-GEL, BU-GER and BU-BEN.
You pipes and brackets must be partially deburred for fitting the sleeves and sometimes something
be milled out so that the sleeves fit absorbent.
Material: S235 JR
- Ø outside: 18 mm
- Ø inside: 15mm
- Wall thickness: 1.5mm
- Length: 400mm
- 2 sleeves with a length of 40mm
The cut edges are not deburred. Please open the package carefully and wear
Protective gloves when unpacking.
Customers also purchased
30,34 EUR RRP 31,93 EUR you save 5% (1,60 EUR)