AIR FILTER, f. 40-45mm carb connections
Product.Nr.: LF-HF43
16,38 EUR
RRP 18,20 EUR
you save 10% (1,82 EUR)
incl. 19 % VAT
If you can't put this article into the shopping cart, we will inform you when the article is available again. Please enter your e-mail address and confirm the incoming mail. Thanks.
product description
Quality air filter with significantly more air flow than
Original air filter. This tuning filter has a metal mesh on the outside
and a fine paper tissue inside.
Ideal for the Caferacer - or conversion of the chopper.
Mass
-Total length: approx. 142mm
-Length of the filter: approx. 127mm
-Connection rubber: approx. 15 mm
-Outer diameter d filter: approx. 71 mm
-Inner diameter d. of connection rubber: approx. 43 mm
This makes this air filter for carburetor flanges by
41-45 mm.
The clamp is included.
ATTENTION: The higher air flow must be the carburetor
newly tuned, otherwise a lean mixture the
Motor can overheat and cause damage. Experience has shown that
are 4-stroke with jets larger numbers of approximately 25-30
(E.g. by size 100 to 125 to 130); the nozzle needle
to raise a ring.
The nozzle Assembly must be even higher for 2-strokes.
Are general guidelines, but the right candle image is crucial.
This should be immediately after full load operation always "Fawn".
This air cleaner is designed for competition use, the
Intake is getting louder. Usually only when older
Years eligible for registration (before approx. 1983, please with the TÜV clarify).
Translated from German by
