Cafe-Racer, Scrambler SEAT, Honda CX500, vintagebrown artificial leather, black square stitching
Informationen zu möglichen Raten
If you can't put this article into the shopping cart, we will inform you when the article is available again.
Please enter your e-mail address and confirm the incoming mail. Thanks.
Beautiful, the highest seat for the scrambler conversion,
suitable for the Honda CX 500.
The base is deep-drawn thermoplastic.
Therefore not so stiff as for example Fiberglass.
This one gives himself experience shows that discussions with the
Auditor on strength and fracture behaviour. Also it saves
Bench seat properly weight: weighs only about 1 kilogram!
-Imitation leather: vintagebraun
-Diamonds seams: black
-Total length: approx. 620mm
-Front width: approx. 170mm (measured on the inside)
-Length of the seat surface: approx. 620 mm
-maximum width rear: approx. 215mm (measured on the inside)
-Other dimensions on request.
The bench is supplied on request with an opinion of the material.
Fits to following Honda CX models
-Built in 1978-1981 (standard model)
- Not suitable for CX500C ("custom" Softchopper, built from 1981),.
and "E" (Euro). Custom models, the Heckrahmenhinter must
the shock absorption are separated, then that can be
Also here fit bench seat with a little craftsmanship.
- Caution: to install of this seat must (also for standard models)
the rear seat mounting bracket are modified, he builds something too high.
Please take note that we retorted, not suitable goods only
full refund without damage .
Therefore make sure the car seat when you place on the frame,
not to damage (E.g. by sharp parts of the frame or by sitting on
without proper installation). Thank you very much!
GB: Cafe racer, Scrambler SEAT, Honda CX500, vintagebrown artificial leather, black square stitching
Translated from German by
Customers also purchased
47,06 EUR RRP 49,54 EUR you save 5% (2,48 EUR)
19,80 EUR RRP 20,84 EUR you save 5% (1,04 EUR)
23,15 EUR RRP 24,37 EUR you save 5% (1,22 EUR)