Universal fits many models.
The removable upholstery frame and the cusps are deep-drawn thermoplastic.
Therefore not so stiff as for example Fiberglass. This man gives himself
experience shows that discussions with the auditor about strength and fracture behaviour.
We recommend a mounting on a stable base.
The upholstery frame can be very easily with only two screws of the saddle
separated and reassemble.
Fits with a little craftsmanship sure on many different machines.
-Total length: 650 mm
-Front width: 158 mm (measured on the inside)
-Length of the seat C: approx. 380 mm
-maximum width rear: 275 mm (measured on the inside)
Other dimensions of this seat on request.
The bench is supplied on request with an opinion of the material.
This as a single bench seat is entered according to TÜV
must be because the seat with their approx. 33 cm length to
is short for the two-man operation.
For the creation of a seat base you will find the following components with us in the shop
|Seat base plate|
|610 x 330 x 10 mm||SB-RET|
|450 x 250 x 8 mm||SB-UPB|
|Black, lightly grained||KL NG|
You will find useful tips and tricks for installing the seat at www.kickstarter.de under 'Tips'
Please take note that we retorted, not suitable goods only
full refund without damage .
Therefore make sure the car seat when you place on the frame,
not to damage (E.g. by sharp parts of the frame or by sitting on
without proper installation). Thank you very much!
Translated from German by
Customers also purchased
incl. 19 % VAT excl. shipping costs