Carburetor cone / funnel, 40-44 mm
Sorry, this item is out of stock. If you like we'll send you an email once it is on stock again.
Please provide your email address, you will receive an email to confirm the notification
Short sieve, conceived for sports use, but rather to show ticks.
The metal parts on the end cap and the foot are high-quality chrome plated.
ATTENTION: By the higher air flow the carburetor must be readjusted,
otherwise a lean mixture can overheat the motor and cause damage.
Experience has shown that with larger nozzles numbers fitted 4-stroke to approx. 25-30
(E.g. size of 100 to 125 to 130); the nozzle needle turn a ring.
The nozzle Assembly must be even higher for 2-strokes. These are general guidelines,
but the right candle image is relevant. This should immediately after full load operation
be always "Fawn".
Eligible for registration only in older years (before approx. 1983, please with the TÜV clarify).
-Total length of the sieve: approx. 51 mm (ink. Gummi-Anschlußstück)
-Maximum diameter at the widest point (chrome-plated ring): 74 mm
-Rubber flange diameter: 42 mm
Fitting on CARB intake manifold with an outer diameter of approx. 40-44 mm. Therefore for example
suitable for the following motorcycles:
KAWASAKI KH 400 (S3F) KAWASAKI Z 900/Z1/A/B/A4 (Z1F) KAWASAKI Z 1000 (A1) (Z1F-A)
SUZUKI GS 550 B (GS550B) SUZUKI GS 750 B (GS750) SUZUKI GS 1000 D (GS1000)
YAMAHA RD 250 (522) YAMAHA RD250 LC (4L 1) YAMAHA RD 350 (521) YAMAHA RD 400 (1A3)
MZ ETZ / TS 125/150 ENFIELD bullet
Scope of delivery including solid, chrome plated clamp.
GB: Cartor Boer cone/funnel, 40-44 mm
Translated from German by
Customers also purchased