product description
The rear frame kit for the professional or hobby screwdriver.
You can make individual adjustments to this rear frame, such as changing the angle or length.
The upper part is already bent, the enclosed tubes and flat iron can be cut to length and welded on as required.
In this way, a tail can be built individually according to your own ideas.
The raw material is very easy to form and weld and is therefore very suitable for changes to the frame and rear section.
Dimensions loop:
- Pipe Ø outside: 25.4mm (approx. 1 ")
- Tube Ø inside: 21.4mm
- Wall thickness: 2mm
- Total length: approx. 210mm
- Width: approx. 198mm (measured from the center of the pipe to the center of the pipe)
- Distance between the pipes inside : approx. 173mm
Dimensions of the supports:
- Tube Ø outside: 25.4mm (approx. 1 ")
- Tube Ø inside: 21.4mm
- Wall thickness: 2mm
- Total length: approx. 760mm
- Angle of the kink: approx. 45 °
- Length to the kink: approx. 380mm
- Length from the kink: approx. 370mm
Dimensions of the struts:
- Tube Ø outside: 25.4mm (approx. 1 ")
- Tube Ø inside: 21.4mm
- Wall thickness: 2mm
- Total length: approx. 740mm
- Angle of the kink: approx. 90 °
- Length to the kink: approx. 360mm
- Length from the kink: approx. 375mm
Scope of delivery:
- 1 tail loop
- 2 pipes as supports
- 2 tubes as struts
Matching inner sleeves for welding can be found in the shop under item number IH-25 .
Manufacturer information on the material used:
EN 10305-3 (formerly DIN 2394-1 / -2) CR1 E195 S3:
CR1: Usually not heat-treated, but suitable for final annealing (BKM)
EN material E195 (formerly DIN St 34-2)
S3: cold rolled
Area of application: automotive industry, mechanical and plant engineering
Rm (N / mm): 374
Rp (N / mm): 358
A%: 39.5
Base: 5.65
GB: High quality, perfectly weldable, steel tube set from 25.4mm pipe: Frame Loop, t wo uprights, two support tubes
Customers also purchased
