product description
The "m.flash" is by far the smallest load-independent flasher relay
on the market. It couldn't be smaller or simpler.
The "m.flash" flasher replaces all conventional flasher relays.
on the market. It couldn't be smaller or simpler.
The "m.flash" flasher replaces all conventional flasher relays.
Advantages
- Ultra small and lightweight, practically just a piece of cable
with a tiny candy-sized device - Ideal for custom bikes and conversions with limited space -
bulky standard flasher relays or load resistors are a thing of the past - It can be routed, for example, in the handlebar tube, frame tube or in the cable harness
- Almost load-independent (min. 1 watt)
- Works entirely with digital semiconductor technology. control over
microprocessor. No mechanics, no coils, no contacts - Always constant and correct flashing frequency therefore suitable
for almost all LED indicators, all micro indicators, halogen indicators,
10 watt turn signal, 21 watt turn signal - Works, for example, with 4 indicators or 2 handlebar end indicators
- Instant, no-loss, brighter turn signal lights
- Super simple connection with only two cables - just connect in series
- Absolutely waterproof and vibration-resistant as it is completely encapsulated
- Short-circuit proof, automatic overload protection. switches
up to 100 watts of power. - No heat development during operation
- Operating voltage already from 5V to 18V
- Also suitable for 6 V indicators
- Quality 'made in Germany' - by motogadget
Hints
The "m.flash" replaces a conventional flasher relay.
This flasher relay is usually located, viewed in the circuit,
BEFORE the turn signal switch. The easiest way
To install the m.flash, look for the original relay
and simply replace it with the m.flash.
The "m.flash" can be used with button fittings
DO NOT replace the button control. Are you looking for a flasher relay for buttons,
You can find this under the article number MG-RE .
NOT suitable for HD motorcycles.
Specifications and Features
This flasher relay is usually located, viewed in the circuit,
BEFORE the turn signal switch. The easiest way
To install the m.flash, look for the original relay
and simply replace it with the m.flash.
The "m.flash" can be used with button fittings
DO NOT replace the button control. Are you looking for a flasher relay for buttons,
You can find this under the article number MG-RE .
NOT suitable for HD motorcycles.
Specifications and Features
| Housing L x W x H | 18mm x 13mm x 9.5mm |
| Length of connection cable | approx. 2 x 50mm |
| Weight | about 4g |
Customers also purchased
