Performance AIR FILTER, diameter 34-38 mm

Product.Nr.: LF-35

9,98 EUR
incl. 19 % VAT

    Ggf. Artikelbeschreibung beachten!

    Ggf. Artikelbeschreibung beachten! Ggf. Artikelbeschreibung beachten!
  • delivery time : Lagerartikel - sofort fertig zum Versand
  • weight 0,41 kg

product description

Quality permanent air filter with significantly more air flow rate than
Original or K&N air filters. Where the original air filter
is made of paper, this tuning filter has a metal mesh outside
and a fine weave inside. Fully washable - oiling
is not applicable. The metal parts at the end cap and at the foot are
high-quality chrome-plated. Ideal for Caferacer- or
Chopper Conversion

ATTENTION: Due to the higher air flow rate the carburettor must be
as otherwise a mixture that is too lean will reduce the
overheat the motor and may cause damage. Experience shows
4-strokes with approx. 25-30 number larger nozzles
(e.g. from size 100 to 125 to 130); the nozzle needle
one ring higher.

With 2-strokes the nozzle equipment must be even higher.
These are guide values, but the correct candle pattern is decisive.
This should always be "fawn brown" immediately after full load operation. etc;

This air filter is designed for competitive use, the
Suction noise is getting louder. Therefore, as a rule, only with older
Years of construction can be registered (before approx. 1983, please check with TÜV).

Available for carburettor flanges in different sizes (see shop).


- length of the filter: approx. 68 mm
- total length (with flange): approx. 86mm
- Maximum diameter at the widest point (lower ring): approx. 72mm
- carburettor flange diameter: approx. 34-38 mm

Includes solid, chrome-plated mounting clamp.

Translated from German by DeepL