product description
Short rear hanger suitable for the XS 400/360/250.
This bracket provides enough space for the assembly of a fender, even with completely einfederndem rear wheel.
Also suitable for other motorcycle frames with the same dimensions.
Please compare the dimensions before ordering and pay particular attention to the pipe pitch and outer diameter of the pipes.
Dimensions:
- Length: about 231mm
- pipe distance (from tube center to tube center): about 210mm
- Ø outside: 22mm
- Material: VA / stainless steel
This bracket provides enough space for the assembly of a fender, even with completely einfederndem rear wheel.
Also suitable for other motorcycle frames with the same dimensions.
Please compare the dimensions before ordering and pay particular attention to the pipe pitch and outer diameter of the pipes.
Dimensions:
- Length: about 231mm
- pipe distance (from tube center to tube center): about 210mm
- Ø outside: 22mm
- Material: VA / stainless steel
Assembly:
For the assembly of the tail arch, an extensive conversion of the stern is required. First you separate the original frame
at the favorite place. Now the tail bow will be adjusted to the desired length. After cutting the sheet is attached to the
original frame welded, sanded and painted if necessary.
The rear conversion is permissible for a registration on a single seat and a professional execution. Please discuss in the
Before the details of your project with the responsible test engineer.
Customers also purchased
