product description
Beautiful seat blank for the Cafe Racer conversion, universally suitable for many models.
The removable upholstered frame and the hump are thermoformed from thermoplastic.
So not as stiff as fiberglass. Experience shows that you give yourself discussions for this
with the inspector about strength and fracture behavior.
We recommend mounting on a stable base plate.
The upholstered base plate can be easily separated from the seat and reassembled with just two screws.
Fits many different machines with a little manual skill.
Dimensions:
- Overall length: 700 mm
- Front width: 165 mm (measured on the inside)
- Length of the seat: approx. 340 mm
- Max. Rear width: 230 mm (measured on the inside)
- Back light diameter: 55 mm
Other dimensions on request.
The seat can be supplied with a material report on request.
Depending on the TÜV, this seat will have to be entered as a single seat because the seat is approx. 33 cm
is too short for two-man operation.
You can find the following components in our shop for assembling a bench:
| foam | |
| 20 mm | SB-S2 |
| 30 mm | SB-S3 |
| 50 mm | SB-S5 |
| 80 mm | SB-S8 |
| Bench base plate | |
| 610x330x10 mm | SB-RET |
| 450x250x8mm | SB-UPB |
| leatherette | |
| Vintage brown | KL-VI |
| Vintage beige | KL-pa |
| White | KL-WS |
| red | KL-RT |
| silver / gray | KL-SI |
| Erdbraun | KL-TER |
| black, slightly grained | KL-NG |
| black, grained | KL-BB |
| foam rubber | |
| MOSS | |
You can find useful tips and tricks for installing the seat in the Kickstarter shop at TIPS .
IMPORTANT NOTE
Please note that we only fully refund returned, unsuitable goods without damage .
Therefore, please take care not to damage the seat when placing it on the frame, e.g. B. by sharp-edged
Frame parts or by sitting on them without professional assembly. Thank you for your understanding.
Customers also purchased
