product description
The rear frame kit for the professional or amateur screwdriver.
On this rear frame you can make individual adjustments, such as angle or length changes.
The upper part is already bent, the enclosed pipes and flat iron can be cut to length and welded as required.
So a tail can be built individually according to your own ideas.
The raw material is very easy to form and weld and is therefore very well suited for changes to the frame and corner piece.
Dimensions Loop:
- Tube Ø outer: 22mm
- pipe Ø inside: 18mm
- Wall thickness: 2mm
- Total length: about 260mm
- Width: about 143mm
Dimensions of the columns:
- Tube Ø outer: 22mm
- pipe Ø inside: 18mm
- Wall thickness: 2mm
- Total length: about 700mm
- Angle of the bend: approx. 45 °
- Length to the bend: about 380mm
- Length from the bend: approx. 370mm
Dimensions of the struts:
- Tube Ø outer: 22mm
- pipe Ø inside: 18mm
- Wall thickness: 2mm
- Total length: about 700mm
- Angle of the bend: approx. 90 °
- Length up to the kink: approx. 350mm
- Length from the bend: approx. 350mm
Delivery:
- 1 rear loop
- 2 pipes as supports
- 2 tubes as struts
Manufacturer information on the material used:
EN 10305-3 (formerly DIN 2394-1 / -2) CR1 E195 S3:
CR1: Usually not heat treated but suitable for final annealing (BKM)
EN material E195 (formerly DIN St 34-2)
S3: cold rolled
Application: Automotive industry, mechanical and plant engineering
Rm (N / mm): 374
Rp (N / mm): 358
A%: 39.5
Base: 5.65
GB: High quality, perfectly weldable, steel tube set from 22mm pipe: Frame Loop, t where uprights, two support tubes
Customers also purchased
