Performance AIR FILTER, diameter 37-40 mm

Universal sport air filter

Quality permanent air filter with significantly more air flow rate than
Original or K&N air filters. Where the original air filter
is made of paper, this tuning filter has a metal mesh outside
and a fine weave inside. Fully washable - insert
is not applicable. The metal parts at the end cap and at the foot are
high-quality chrome-plated. Ideal for Caferacer- or
Chopper Conversion

ATTENTION: Due to the higher air flow rate, the carburetor
as otherwise a mixture that is too lean will reduce the
overheat the engine and cause damage. Based on experience;
4-strokes with about 25-30 numbers larger.
(e.g. from size 100 to 125 to 130); the needle
to make a ring.

With 2-stroke engines, the performance must still be higher.
These are approximate values, but the correct candle pattern is essential.
This should always be "fawn brown" immediately after full load operation. etc;

This air filter is designed for competitive use, the
Suction device gets louder. Therefore, as a rule, only for older people
Registration required (before 1983, please check with the TÜV).

Available for carburettor flanges in various sizes (see shop).

Measures
- Length of the filter: approx. 68 mm
- total length (with flange): approx. 86mm
- Maximum diameter at the widest point (lower ring): approx. 72mm
- carburettor flange diameter: approx. 37-40 mm

Includes solid, chrome-plated mounting clamp.