D.I.Y. REAR FRAME KIT, Ø25,4mm (1")/255mm, f. various motorcycles

The rear frame kit for the professional or amateur screwdriver.
On this rear frame you can make individual adjustments, such as angle or length changes.
The upper part is already bent, the enclosed pipes and flat iron can be cut to length and welded as required.
So a tail can be built individually according to your own ideas.
The raw material is very easy to form and weld and is therefore very well suited for changes to the frame and corner piece.

Dimensions Loop:
- pipe Ø outside: 25,4mm (about 1 ")
- Tube Ø inside: 21,4mm
- Wall thickness: 2mm
- Total length: about 590mm
- Angle of the bend: approx. 10 °
- Length to the bend: approx. 345mm
- Width max .: approx. 255mm
- width in front: approx. 195mm

Dimensions of the columns:
- pipe Ø outside: 25,4mm (about 1 ")
- Tube Ø inside: 21,4mm
- Wall thickness: 2mm
- Total length: about 620mm
- Angle of the bend: approx. 45 °
- Length to the bend: approx. 520mm
- Length from the bend: about 90mm

Dimensions of the flat iron:
LxWxH: 250x25x4mm

Delivery:
- 1 rear loop
- 2 pipes as supports
- 2 flat iron

Suitable inner sleeves for welding can be found in the shop under the article number IH-25 .

Manufacturer information on the material used:
EN 10305-3 (formerly DIN 2394-1 / -2) CR1 E195 S3:
CR1: Usually not heat treated but suitable for final annealing (BKM)
EN material E195 (formerly DIN St 34-2)
S3: cold rolled
Application: Automotive industry, mechanical and plant engineering
Rm (N / mm): 374
Rp (N / mm): 358
A%: 39.5
Base: 5.65

GB: High quality, perfectly weldable, steel tube set from 25.4mm pipe: Frame Loop, t where uprights, two support strips